Making a Edgecam postproc.

[stefanbaarstroe]

Hello..

I am making a postproc. for a heidenhein ITNC 530. It is used on a Hermle C30U 5ax

Are there enyone who knows where i can find out what commands i can use in my post proc.??

;CODE:#USER8=0
;CODE:%IF #USER8=0 @TEST
#MACRO=0
ETC...

And what are macros??

And how I can get it to make cord every time instead of sub. cords (LBL) after drill cycles even i choose controller instead of pathtrace in the drill cylce

[azores]

this post is not complet yet for the 4th and 5th axis but will give you most of the basic of the 3 axis and the cycles you will need have a look