| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-05-2006, 11:29 AM
| |||
| |||
| Ge Fanuc 18t Is there a paramater to turn on the work coordinates G54-G59 so I can see them on the work shift page,I have seen this on other controls,on this control I can see them in the system page but would have to set them through MDI. thanks    |
|
#2
03-05-2006, 01:18 PM
| ||||
| ||||
| Check to see if you have parameter 9930 bit 1 set. (2nd bit from right). Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
03-06-2006, 06:13 PM
| |||
| |||
| I tryed the 9930 paramater, didn't work, any other Ideas? |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
