| | |
Will Mach3 and Kcam work installed on the same computer. Not at the same time obviously but independently?
The reason I'm asking is they both install a parallel port driver of some sort.
Thanks
They should, but I'm not sure. Mach3's driver only runs while Mach is running.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Posting Permissions
| | |
LinkBack URL
About LinkBacks
