| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CAM Discussion Discuss CAD/CAM software and Design software methods here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-17-2009, 12:31 PM
| |||
| |||
 I am thinking of purchasing Featurecam and new to CNC. I need to make 81 pockets of the bottom half of a 1" sphere and need to duplicate the motion in 81 different XY locations to reduce the size of the program. I have an older Viking 3 axis vertical CNC mill with limited memory. Any help or suggestions would be GREATLY appreciated.  |
|
#2
07-21-2009, 01:35 PM
| |||
| |||
You should look at EZ-CAM. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| advice needed | teamjnz | Haas Lathes | 2 | 05-20-2009 05:19 PM |
| Advice needed. | Terence E | CNCzone Club House | 0 | 05-14-2009 09:56 AM |
| Advice needed. | tomshep | Benchtop Machines | 4 | 10-01-2008 04:59 PM |
| advice needed / to buy or not??? | teamjnz | General Metal Working Machines | 13 | 08-27-2008 08:48 AM |
| Little advice needed | STUG | DIY-CNC Router Table Machines | 1 | 01-25-2005 07:11 PM |
| | |
Linear Mode
