| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CAM Discussion Discuss CAD/CAM software and Design software methods here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-01-2007, 07:54 AM
| |||
| |||
I'm really new to this so bear with me. I downloaded the micro tech cnc simulator yesterday and tried to write my 1st program, but when I added in a g73 for a roughing pass it just read the line and kept going. My question is does this sim run Fanuc canned cycles or am I doing something wrong? Thanks Rich    |
|
#2
08-01-2007, 08:54 AM
| ||||
| ||||
| I believe it has been noted in the past that some of the canned routines do not work as predicted, I have never got G83 peck drill to work as expected. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| microtech cnc simulator | deji | General CAM Discussion | 2 | 05-19-2007 08:31 AM |
| | |
Linear Mode
