| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CAM Discussion Discuss CAD/CAM software and Design software methods here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-20-2007, 06:54 PM
| |||
| |||
I have a Fadal15XT and am trying to balance a new Y-axis amplifier card that I have installed. I need the G-code to perform a straight diagonal move that loops un-interrupted while I adjust the gain and signal screws in the board. This is as far as I have got and this stops after one cycle. % O1 M6 M49 M98 G0 X5.0 Y5.0 S3000 M3 E1 G0 Z11.0 G1 Z11.0 F50. X-5.0 Y-5.0 Z3.0 F150. X5.0 Y5.0 Z11. M99 % Apparently I need an M49 that cancels out an over-ride and M99 for a loop command. Can anyone tell where I am going wrong?    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1/4" npt need g code program | imwllc | General Metal Working Machines | 3 | 08-20-2011 11:12 AM |
| Mazatrol Program into a G Code Program | fuzzman | Mazak, Mitsubishi, Mazatrol | 14 | 02-08-2010 04:55 PM |
| help with loading program from card to oi fanuc control | dismal | Daewoo/Doosan | 4 | 03-21-2007 11:00 PM |
| Current balancing | pdmech | Phase Converters and VFD | 0 | 03-21-2006 08:52 AM |
| VFD Balancing? | Edster | Fadal | 17 | 02-27-2006 02:48 PM |
| | |
G-Code program for amplifier card balancing 
Linear Mode
