Interview with Greg Milliken, CEO of Alibre - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > CAM Software > General CAM Discussion
Interview with Greg Milliken, CEO of Alibre

General CAM Discussion Discuss CAD/CAM software and Design software methods here!

This forum is sponsored by:

04-18-2007, 11:47 AM

folini

Join Date: Mar 2007

Location: USA

Posts: 17

Interview with Greg Milliken, CEO of Alibre

permalink

Hi,
I recently interviewed Greg Milliken, CEO of Alibre. Greg talks about himself, the Alibre strategy, and the future of 3D CAD software.

If you are interested here is the link to the interview on the Novedge blog.

Franco Folini

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
An Interview with Victor Gonzalez, CEO of Next Limit (Maxwell Render)	folini	Rhino 3D	0	04-16-2007 12:31 PM
An Interview with Ron Fritz of TechSoft3D (Hoops 3D)	folini	General CAM Discussion	2	03-22-2007 02:34 PM
An Interview with Bob McNeel, CEO of McNeel and Assoc. (Rhino 3D)	folini	Rhino 3D	2	03-15-2007 01:05 PM
Alibre/ Alibre xpress	moyesboy	Alibre Design	11	01-25-2006 02:41 PM

All times are GMT -5. The time now is 02:15 AM.