convert smartcam to dxf format? - CNCzone.com-The Largest Machinist Community on the net!

imfool · #1 03-21-2004, 08:31 PM

i am completely new to this stuff. i have been asked to convert quite a few Smartcam Wire Edm files to .dxf format if possible? unfortunately, i do not have smartcam wire edm package. As far as i understand this package is not supported anymore. i did write to smartcamcnc.com who just bought the package and am waiting to hear from them.

The client who is providing the files does not have this software any more. are there any converters that can help me convert these files to dxf format?

any help/suggestions is appreciated. i have very little idea of what i can do.

warm regards
-imfool

CHAD · #2 03-22-2004, 05:17 AM

SEND THEM TO ME I WILL CONVERT THEM FOR YOU

imfool · #3 03-22-2004, 06:23 AM

hmmm...

Chad, the problem is that I have 500-1000 such files from my client... i am assuming that u have to open each file and convert it seperately. or can you write a script to do so?

gaurav

CHAD · #4 03-22-2004, 07:27 AM

YOU ARE CORRECT, THAT WOULD BE THE PROCEDURE. IF IT END UP THAT'S YOUR ONLY CHOICE, I COULD HELP.

imfool · #5 03-23-2004, 09:15 PM

HI Chad,

Looks like I may need help... can you check your PM.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
G-Code to DXF	WayneHill	OpenSource Software	200	04-22-2012 09:51 PM
DSTV file format?	ABC123	General CAM Discussion	7	01-16-2009 05:37 AM
jpeg convert to dxf...can I do this?	mredican	Autodesk Software (Autocad, Inventor etc)	5	05-05-2005 11:32 AM
DXF Catalog	CNCdude	Product Announcements & Manufacturer News	2	08-26-2004 09:07 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)