Looking for a Site w/ TEF motor models

[JerryFlyGuy]

Hey I've been looking for a site w/ some decent TEF motor's that a guy can download. I'm looking for a 40-50hp. If all else fails some place that show's the dimensions would work too..

And no, this isn't a motor I plan to put on my Mill But it will go on a saw w/ 26000 sfm cutting ability..

Thanks
Jerry

[DareBee]

G'Day Jerry

Doesn't 3D Content Central have any?
No I haven't checked for you.
Get drawings from Leeson - they should be online - my catalogue has them.
An SW guy like you won't take long to make a dummy model with correct critical dims (I find it quicker than searching the net in most cases).

[JerryFlyGuy]

I got a dummy model already t'is just a can w/ filleted ends.. but doesn't look to good when the rest of the unit is detailed to the nine's. I'll check out 'central' as I haven't looked there yet. I'm a little leery of using stuff off there as there is no 'checks' to make sure published stuff is actually scaled properly. Getting a model off a suppliers website is a bit less worriesome..

I'll check out Leeson as well.

Thanks Darebee

Jerry