Deskengrave broken

[macona]

I cant seem to get deskengrave to work. Anyone else have this problem? Here is a copy of gcode output of the word TEST I have tried it with two computers (Both under XP) and the same result.

[CNCRim]

you might want to take a look at parameter you are setting.

[ajaymd]

THE parameter which is giving you 0s is the decimal points.
By default it is set at 0 - so the multiple of 0 is all 0s
So you need to go in and write 2, 3, or whatever resolution you need and this should solve the 0 problem
Good luck
I am a novice too just put together my own small CNC from all the ideas from the net.
Ajay