Fonts for Routering & Engraving - CNCzone.com-The Largest Machinist Community on the net!

DaSigntist · #1 12-29-2003, 08:24 PM

Would anyone know where I can find single and multi line engraving type fonts (.ttf)?

Like in the image below.......

High Seas · #2 12-29-2003, 09:19 PM

Have you checked out the FREE DeskEngrave @ www.desKAM.com ? It does the ttf selection from files on your system. Also does the arcs - but I haven't seen/tried the reverse/left-leaning italic though. Someone asked recently regarding "single stroke" lettering - I did a quick look and the DeskEngrave didn't seem to do that. But HEY its...FREEEE

Jim

DaSigntist · #3 12-29-2003, 10:12 PM

Thanks I have seen it but I'm looking for the single and 2 , 3, and 4 line fonts that engravers use.

The problem with true type fonts is you get that outlined look.

I'm with you, If its free I'm there!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using CNC Mill for Engraving	studysession	General Metal Working Machines	25	10-22-2006 09:15 PM
Engraving machine help	Marc	DIY-CNC Router Table Machines	6	07-01-2006 08:08 PM
single line fonts?	balsaman	General CAM Discussion	12	02-18-2006 11:51 AM
Engraving Software	The Wizard	General CAM Discussion	31	03-29-2005 05:38 AM
Intro + engraving bits	Swede	General Metal Working Machines	7	02-07-2004 02:47 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)