Please help! I'm a total NOOB and I'm working with LaserCut 5.3. When I set the laser to cut the outer area and engrave a design in the middle, it does not engrave as lines it engraves the whole inner portion of the set engraved area (turns it all red in simulate.) I do not know what to set or change to the engraved area so it will only cut as lines not as a whole area.Example: if I want to engrave a heart (the outer lines) it instead engraves the whole heart inside and out taking up a lot of time and sometimes burning through. I hope I explained this good enough. Sorry for confusion