winpc and artcam

[saggra]

hi i have artcam 8 and win pc and find the right post processor to someone can help me please

[bansheesa]

Hi, new here and no pro. I have the same problem. I am running Artcam 8 Pro and I am looking for a Postprocessor for my Heiz S720 running Winpc-nc Usb version. At the moment I am using the flexicam post and works ok. Problem is that the feed rates are way off.

Please, help would be appreciated.

[bansheesa]

Anyone?

[jonroger]

I use Artcam and Winpc nc-USB version.
I use G-code (mm) or (inch). I use (mm).
And it works well.

[FlexiCAM]

You can also try the Multicam HPGL post.

If you have problems with speeds in the post why not just output without feedrates and set the feedrates in the WinPCNC HMI?

[redriver.1]

Hi Bansheesa

Try these i think will sort you out..
[URL="http://winpc-ncATC Arcs mm(*.nc)