Looking For a good cad/cam w/ 4th axis - CNCzone.com-The Largest Machinist Community on the net!

fc911c · #1 09-30-2005, 02:53 PM

Hi guy's

I was looking at the Rhino software and wanted to know what you think of it.
It's a bit pricy but for the things I wan't to do using a 4th axis I don't think there is a cheep way out. Am I wrong, is there a better way? I am using Mach3 to run my mill.

Any help would be greatly apreciated

Thanks

Frank

DareBee · #2 10-03-2005, 08:20 AM

I don't know of any full 4 axis for less money.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)