Solid surfacing/ Alphacam

[r3builders]

Hey guys, Im new to the forum but its good to see that theres one out strictly for people like us, anyways Im very new to solid surfacing in alphacam, there not to keen on giving any info unless I pay them out my butt so with that said I need help! I have two cosmec conquest 250s, what im trying to do is make a 3d solid surface and use a flat bit to do it, I dont have any 3d engravers at the moment but Im pretty sure I have 2 v bits laying around. Ive attached what Im trying to use its in .dxf and .jpeg just to take a look at, keep in mind im a hardcore newbie when it comes to any type of 3d
or surface mounting, any step by step would be beyond appreciated. The thickness of the material would be 2.5 inches and the top of my spoil board im at .75.

and this bat gif is cool