Require DXF/DWG for 35 tooth sprocket. - CNCzone.com-The Largest Machinist Community on the net!

Kiwi · #1 06-15-2009, 04:42 PM

Hi, I need a drawing of one tooth for a 35 tooth sprocket to suit a 428 roller chain.
I have the specifications from the Machinery Hand Book but will need to do some trig if drawing not available. Thanks.

Karl_T · #2 06-15-2009, 04:55 PM

http://www.gizmology.net/sprockets.htm

karl

Kiwi · #3 06-15-2009, 05:10 PM

Thanks Karl
That's much simpler than what the specifications call for, but I'm sure that's all I really need.
Cheers.

easymike29 · #4 06-15-2009, 10:46 PM

http://idleamusements.com/Software/sprocketeer2.htm
Gene

Kiwi · #5 06-16-2009, 02:56 AM

Gene, Thanks for the site link, that makes things a lot easier. Cheers.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Saburr-tooth burrs	cncbcncb	Wood Working Tooling	1	03-26-2009 07:13 AM
Where to buy 24/32 TPI straight-tooth set 131-1/2" Blade? + Q on wavy tooth sets	mcm375	General Metal Working Machines	2	11-25-2008 09:28 PM
Hardinge HLV-H Lathe, change gears, 127 tooth	leeputman	General Metal Working Machines	6	01-18-2008 07:29 AM
can I get a 13 tooth timing pulley	unterhaus	Bridgeport and Hardinge Mills	9	01-11-2006 10:11 AM
Cutting A Ten Tooth Spline On Vmc With 4th Axis	rrrrrgh	G-Code Programing	5	08-19-2005 04:33 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)