Reply with QuoteA needle scaler with a chisel tip works about the best.
Slag Removal?
Simple question: I am fairly new to this whole plasma cutting thing and curious as to what you guys use for slag removal on cut parts? Do I just need to get a needle scaler?
Similar Threads:
A needle scaler with a chisel tip works about the best.
On all equipment there are 2 levers...
Lever "A", and Lever F'in "B"
maneric acid works good. mix with water 50/50 in a plastic tub do not use a steel tub in time it will eat through it. also the acid we desolve aluminum!!!!
If your tip is in good shape, air is clean & speed is just right. You shouldn't have a lot of slag to remove. Sometimes a short length of flat bar works pretty good too. Slide the end of it along the plate perpindicular to the slag banging into it.
If it works.....Don't fix it!
Posting Permissions
