Need Help! Omax 5555 - cannot lower pressure to 20 KSI


Results 1 to 2 of 2

Thread: Omax 5555 - cannot lower pressure to 20 KSI

  1. #1
    Registered
    Join Date
    Aug 2017
    Location
    United States
    Posts
    4
    Downloads
    0
    Uploads
    0

    Angry Omax 5555 - cannot lower pressure to 20 KSI

    Good day all. We have an Omax 5555 and cannot reduce the cutting pressure to 20 KSI. At present we can only get the pressure down to 21.4 KSI at 644 RPM. We are running water only with a .005 sapphire jewel, a .005 dump valve jewel, and a .010 excessive overflow jewel. We have replaced all of the jewels, rebuilt the dual on/off valves and also the air actuators. We have run this set up for years and had no problems with our 3050 pump running at 20 KSI. Any ideas?

    Similar Threads:


  2. #2
    Registered
    Join Date
    Oct 2017
    Location
    United States
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Re: Omax 5555 - cannot lower pressure to 20 KSI

    do you not have a low pressure setting in your setup screen?



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Omax 5555 - cannot lower pressure to 20 KSI

Omax 5555 - cannot lower pressure to 20 KSI