Do you have any schematic drawn up?
Al.
Do you have any schematic drawn up?
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
No, was trying to get out of paying $75 to DoAll for it.
Looks like a standard 3 wire ON/OFF control. If the wiring hasn't been disturbed, connect your 3 phase input to the main switch at the top right of the box. Make sure the saw is wired for your input voltage. I can't see the label on the transformer to tell you what the input voltage is.
I assume the buttons are labeled Start, Stop and Light
Jim Dawson
Sandy, Oregon, USA