Microtec 3000 cnc milling machine anybody !

[otpco]

Hi all have got myself A Microtec 3000 cnc milling machine .
Yes the fun is starting Any one know anything avout them . Its a nice piece of iron .
But the control has me guessing .I have a bit of the manual .I am chasing a bit of information about the electronics boards .
anything would be good

Similar Threads:

• Need Help!- In need of a metal-capable machine for around $3000
• Best Machine Under $3000? [6040 vs X6?] -- Details Inside!
• 3 AXIS MACHINE 1500*3000*350MM
• Need help MultiCam 3000 machine
• BRIDGEPORT "TEXTRON" CNC MILLING MACHINE - 3 AXIS -3000 MK ANILAM CONTROL

[otpco]

Bump there must be somone who has even seen one of them . It has sanyo brushed servo motors with no labels on them no model nos nothing ... it makes it hard

[awerby]

One of these: https://www.wotol.com/1-microtek-300...rod_id/1271497 ? If it has brushed servos that don't draw more than 20 amps, you should be able to drive it with Gecko 320 drives: Geckodrive Brush DC Drives | GeckoDrive That might be easier than trying to run modern programs on what's undoubtedly an obsolete controller with very limited memory. Even if the old controller works perfectly (which is unlikely) computers have improved somewhat since the 1980s.

[otpco]

Yes have been looking at that option . It would mean running the motors at half there capacity . I wish rites was still alive !! I will keep looking

[awerby]

You think those motors really draw 40 amps? That's a lot.

[olslowhand44]

I have one! I need a y-axis servo motor (repaired or replaced)
Sanyo Denki Step-Syn 103 8932-0210