Any suggestions welcome

I have bought the awc708lite controller with 2m145 stepper drivers. The power supply is MYJG100W.

The laser cuts perfectly , however after a while, when engraving the laser freezes the x axes or Y axes depending which is used for engrave. When restarting the stepper driver it is all good again.

If engraving without water protect - when the laser is not shooting ( the laser power supply MYJG100W off) it can engrave even on 300 speed and not stopping or excreta.
That is veered why when engraving it malfunctions, but when cutting all is fine. Why switching of the laser power supply it engraves perfectly - virtually of-course. The laser power supply not co-potable with the AWC708 lite controller? Or the stepper drivers to sensitive?

Thank you

Similar Threads: