OKK w/Fanuc 15-M Problem

[wdhuffman]

Hello Everyone,

I have exhausted my resources and was sure a some of you might have more or better information than I can get my hands on.

I have an operator message that I cant find a solid definition of.

The Spindle Drive is part number A20B-1003-0010 paired with A20B-1003-0120. I have at this time replaced the -0010 board and still have the same behavior as with the old.

If anyone can point me in the right direction, I would certainly appreciate the input.

Thanks,

Similar Threads:

• Fanuc PML-L&M Problem
• fanuc 10m problem
• fanuc 10M problem
• Need Help!- PROBLEM ON FANUC 0GD
• Fanuc OMB Problem