- North America Multicam Plasma 3000 Error Msg XA 1 or 17
-
Registered
Multicam Plasma 3000 Error Msg XA 1 or 17
Have the above Muticam and getting screen messages:
Motor Fault XA 1 (sometimes 17)
RMS Torque too high
Possible root cause
Mechanical Problem
Motor cable Short.
Check cabling and that seem fine. some one checking Mechanical Problem now since unit is in off condition is hard to move.
Thanks, ED
Similar Threads:
-
- North America Multicam Plasma 3000 Error Msg XA 1 or 17
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules