- Finding straight for linear 10 foot bearing rail alignment
-
Registered
Finding straight for linear 10 foot bearing rail alignment
I have read a few older posts but none addressed the finding an original datum. I have a 4' x 8' table that has a vertical arc on (Y) which is high in the center. It could be straight and slope down on one end, I dunno. But straight, it is not. The bearing rails are of the self supported round type. I am seeking suggestions for measuring/determining/indicating straight on the upper section/tangent of the the rail.
Thanks
Similar Threads:
-
- Finding straight for linear 10 foot bearing rail alignment
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules