- North America Fanuc O-MF Lost Parameters
-
Registered
Fanuc O-MF Lost Parameters
Good day,
I have a Fanuc MCV-1000AP with O-MF control. I have a 1046 Z-Axis Over Travel alarm. We found out that the parameters were deleted when operator was trying to clear program memory. We entered all parameters, Diagnostic, and other parameters that we had. Every Axis will move manually, and go to home position and Home out. But the 1046 Z-Axis Over Travel Alarm will not go away. Has anyone experienced this before? Should could use some help on this one. We called out some contract help and they could not figure it out either. Thanks ahead of time.
Similar Threads:
-
- North America Fanuc O-MF Lost Parameters
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules