- AP100 Auto Tooling Setting
-
Registered
AP100 Auto Tooling Setting
Hi all,
I want to ask. If I used Auto Entire Part in AP100 for chamfer, it will use nibbling as auto setup.
I have 45degree square tooling, how to make sure the software will use this tooling when I use auto setup for chamfer?
Thanks.
Similar Threads:
-
- AP100 Auto Tooling Setting
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules