- Please Help..Anyone using Mitsubishi Meldas M50 out there ?
-
Registered
Please Help..Anyone using Mitsubishi Meldas M50 out there ?
First probably should have posted in another forum....but not getting much response in the Mitsu forum. Just wanting to know if someone using this controller can point me in right direction for setting up tool offsets. I am using Type 1. I believe its parameter 1036 that toggles between the 2. Setting the length is pretty obvious just enter tool number and length in Data. But cannot figure out where to set diameter of tool and radius ? It can only be 1 of 2 places. In the LIFE or REGIS tab. Just need a shove in the right direction and I can take it from there. Thanks in advance !!
Similar Threads:
-
-
Registered
Re: Please Help..Anyone using Mitsubishi Meldas M50 out there ?
- Please Help..Anyone using Mitsubishi Meldas M50 out there ?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules