- Engraving Font
-
Registered
Engraving Font
What are some of the best fonts to select when engraving in wood? I have tried a few different ones but haven't gotten the best results. With some fonts only part of the letter or words are recognized as chains. Other times the letters have too many small parts to them. I was just wondering which ones everyone seems to have the best success with. Especially with the cursive type fonts.
Similar Threads:
-
-
Member
Re: Engraving Font
There are many factors I have used mini v cutters 30Deg and 60 deg also half mm flat for very fine ,then there is a question of raised lettering .I also use hard woods for small things I have done a little pine to no good effect .goog cnc signs that should give you heaps to look at .
- Engraving Font
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules