Hello, this is my first post, I just bought a homebuilt plasma table with Solid edge, Sheet cam, and Mach 3 as the software's. Has a Hypertherm 45 as the cutter and Gecko G540 as the controller. It is currently set up as touch in go for height control. I haven't yet learned the lingo so searching has been difficult.

I am running into the issue of warping and cutting non flat raw material which ruins the cut and consumables. Its been years since Ive used a plasma table prior to this but the last one had a manual height adjustment remote used manually during cuts. I am asking about this because I assume this is a way to save on cost. My question is how to set that up with the setup I have? Where can I find the remote?

Similar Threads: