basic machining question


Results 1 to 2 of 2

Thread: basic machining question

  1. #1
    Member
    Join Date
    Apr 2004
    Location
    Lincoln, Ne
    Posts
    79
    Downloads
    0
    Uploads
    0

    Default basic machining question

    here's and even more basic machining question about rotary tables. Is there a lot of backlash in a rotary table? I see that nobody, meaning phase 2 yuasa the main brands ext. claim anything about backlash. what could one expect before buying? Is there a lot of difference between an import 8in rotary table and a domestic? Or will either get the job done. thanks in advance

    Similar Threads:


  2. #2
    Member
    Join Date
    Apr 2003
    Location
    Ohio, USA
    Posts
    1873
    Downloads
    1
    Uploads
    0

    Default

    There would be some backlash in either one, you could expect less in the the high quality units, It is common practice that once you start a rotation not to back off and re-start. This essentially negates any backlash. The Phase II and I would presume the higher quality units as well have some backlash adjustment, the Phase II I have does not remove it all.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

basic machining question

basic machining question