new to the forums, but from what i can see lots of good dialog going back and forth, hopefully i can draw on some of your knowledge and share some of mine (limited as it is)
so to start off with a bang, i was wondering if anybody has any knowledge or experience with cutting thick stainless or aluminum using shop air as opposed to nitrogen?
i have been doing some research, and from what i have been reading, this has come a long way in the past year. the trick seems to be in the ability to increase your line pressure from a standard shop pressure.
what i can't seem to find is how much pressure is required. we are currently looking at putting a new compressor in our shop, and would love to know if this is possible before we do so.
if anybody has any info they could share on this or on any successes or failures, it would be greatly appreciated.
Air Cutting Stainless and Alluminum
Posting Permissions
Reply with Quote