Need Help! BLUM LASER NT WITH HEIDENHAIN CONTROL MEASUREMENT ISSUE


Results 1 to 1 of 1

Thread: BLUM LASER NT WITH HEIDENHAIN CONTROL MEASUREMENT ISSUE

  1. #1
    solowalker41's Avatar
    Join Date
    Nov 2014
    Location
    Rawalpindi
    Posts
    9
    Downloads
    2
    Uploads
    0

    Default BLUM LASER NT WITH HEIDENHAIN CONTROL MEASUREMENT ISSUE

    Hi i am using Blum Laser NT for measuring ball nose of 12 mm of Dia using 584 TCH PROBLE Cycle.
    I am predefining all of the parameters in the TOOL list according to the attached Picture.
    But after measurements it updated the tool lengh and Diameter with the differnce of 3mm in Length(i have measured the tool length on tool presetter) and .6mm in Diameter.
    I am unable to resolve this issue . If anyone knows about this, help me plz. I will be thankful.

    Similar Threads:
    Attached Thumbnails Attached Thumbnails BLUM LASER NT WITH HEIDENHAIN CONTROL MEASUREMENT ISSUE-capture-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

BLUM LASER NT WITH HEIDENHAIN CONTROL MEASUREMENT ISSUE
BLUM LASER NT WITH HEIDENHAIN CONTROL MEASUREMENT ISSUE