This is not laser for direct cutting or engraving so there is no way to add any lens.
I have occasionally read some Laser post in various forums for the past 10 years but never had a laser so was not really serious.
Now more or less out of the blue I own a laser.
I bought it off ebay, supposedly in working order but there is no lens or final aperture.
10000MW 808NM Infra Red DIODE LASER SYSTEM
OEMLaserSystems
The laser has a flexible Fiber Optics patch cable but there is nothing terminating it.
I "believe" the end is just a FC/PC connector.
What and where do I get a terminator? What do I need? Links to products really appreciated.
It really appears to be a nicely made unit.
Thanks, I appreciate the help.
Ralph
This is not laser for direct cutting or engraving so there is no way to add any lens.
CNC lasers, constructions, service
re: "This is not laser for cutting or engraving so there is no way to add any lens."
Thanks for the reply, I will learn the logic of your comment but for now let's just talk about a lens.
Here is what I have:
I have a flexible patch cable with FC/PC or SMA905, this is a threaded end. I am picturing a lens holder with the same thread. I will try to determine the thread looks like a fine thread 8mm.
Do you know a source for such a lens or any lens for that matter, possible I will have to make up a holder.
We will talk about "is not laser for cutting or engraving" later.
Ralph
Here is what I was looking for!!
I also found them on Edmunds Optics but they cost twice as much on Edmunds.
If I can actually get things to work I can go to higher quality.
Thanks for all replies.
Ralph