I've been searching here and online for a few days now and I can't seem to get a clear answer on whether or not it's safe for me to adjust the "Frequency" setting under the "Advanced" button in RDWorks. This is the setting that defaults to 20k.

Some posts seem to recommend changing this for better results on Acrylic edge polishing or cardstock. Some say that a chinese glass tube laser can be damaged by changing this. I understand this is fine for metal RF tubes but I don't know how it applies my setup.

Specifically for a RECI tube is it OK to adjust this value? It does seem to have an effect as I played with it briefly before seeing the warnings online.

Thanks!

--Christopher

Similar Threads: