I'm a relatively new operator of our Amada LC-2415a3 machine and am having a perplexing issue. We just changed both the oxygen and nitrogen tanks this morning since they were low. Now, with either nitrogen or oxygen, I'm gettin about 2 seconds into cutting before the gas pressure suddenly drops off, halting in an alarm.
What could I try to troubleshoot this? I'm basically an intermediate novice so any and all information would be greatly appreciated. Thanks!
If you're using the liquid tanks I would check the pressure on them. Sometimes when a new liquid tank is delivered the pressure is too low to cut and we have to turn the pressure builder knob to achieve the required cutting pressure. If you're using 12-pack cradles, ensure that all 12 valves are open.
I have no experience with Amada lasers but this is where I'd start.