Hello All,

I have a Versalaser VL300 that I cut allot of chipboard on. Recently I have been experiencing an issue where I'm getting allot of burning. I checked the focal length and that looks good. Is anyone plotting using AutoCAD and if so when you go into the page setup on the left hand side there are areas labeled "Plot Style Table", " shaded Viewport Options", and "Plot Options" what do you have these set at. I'm curious to see if any of my students were playing with the settings and that maybe where some of my issues might be coming from.

My other thought was there is a nozzle that blows air onto the cut to clear smoke and debris, and maybe that is getting plugged up and not allowing the air to flow freely.

Similar Threads: