Hello everyone. I have been spending a lot of time working on this machine and need some help.
I recently purchased a Lasersaur controller. I installed it and it appeared to be working, although I needed to align my mirrors better and fix the ventilation (since the K40 outlet is very poor and small).
After taking out the X/Y bed and re-installing it, the machine would not home. It kept banging against the end of travel once it engaged the home flag.
It is banging in both X and Y.
I put a video of the problem and the error message I am getting.
Any guidance or advice is greatly appreciated.
Similar Threads:
- New Machine Build- lasersaur, anyone?
- Australia Laser Cutter Upgrade
- Need Help!- Laser Bed Upgrade
- Home/Limit Switch Upgrade