Hello! I have recently acquired a Pinnacle M series laser. I am in the process of getting it up and running. So far, I have sent the laser tube out for refilling and nowI found out that it is the Mercury I controls and can only install the print drivers on a 32bit PC, so I had to buy me a cheap 32bit pc to run the darned thing. Now I have realized that the auto focus is not working. When I try to focus it, it will just keep going up until it hits the top limit switch. So until I figure that out I will need to use the manual focus gauge. I have a 2" lens so I guess I need the blue 2" manual focus gauge. Does anyone have dimensions on this thing so I can make my own. I did not get one from the friend that gave me this laser and calling SignWarehouse does not work since they never answer their tech support line or call back. Any help would be greatly appreciated. Thanks -Shawn

Similar Threads: