- Need Help!- EDM
-
Registered
EDM
I’m looking to buy a EDM I’m learning about them now. Need help on what direction to go..small table is ok and a Z of 6-7 inch’s.
-
-
Member
Hello, this is George Vethamuthu from South India, I am the service engineer for EDM Wedm machins, I have few machins for your training support.. if you are interested pls contact my what's up no +919940379363
- Need Help!- EDM
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules