Hello, im using Charmiless robofil 440sl machine, the problem is now that program graphic map is not in the same position as program. When i load the program as i shown below the program goes to starting point then i cancel the program and load the "graphic map", but then the graphic shows that the cursor is not in the same position as the program? Maybe there is somthing to set up, or the g or m code to add graphic to the cordinates?

%
O0001
N100 G0 G21 G90
N110 G0 X0. Y0. Z250.
N120 G92 X-18.4142 Y-.588
N130 M60
N140 M35
N150 M81
N160 S501 N170 G41 G1 X-7.5 Y-7.5 Z0.
N162
N164
N166
N180 X27.5
N190 G40 X-18.4142 Y-.588
N200 G41 G1 X-7.5 Y-22.5
N210 X27.5
N220 G40 X-18.4142 Y-.588
N230 G41 G1 X-7.5 Y-37.5
N240 X27.5
N250 G40 X-18.4142 Y-.588
N260 G41 G1 X-7.5 Y-52.5
N270 X27.5
N280 G40 X-18.4142 Y-.588
N290 G41 G1 X-7.5 Y-67.5
N300 X27.5
N310 G40 X-18.4142 Y-.588
N320 G41 G1 X-7.5 Y-82.5
N330 X27.5
N340 G40 X-18.4142 Y-.588
N350 G41 G1 X-7.5 Y-97.5
N360 X27.5
N370 G40 X-18.4142 Y-.588
N380 G41 G1 X-7.5 Y-112.5
N390 X27.5
N400 G40 X-18.4142 Y-.588
N410 G41 G1 X-7.5 Y-127.5
N420 X27.5
N430 G40 X-18.4142 Y-.588
N440 G41 G1 X-7.5 Y-142.5
N450 X27.5
N460 G40 X-18.4142 Y-.588
N470 G41 G1 X-7.5 Y-157.5
N480 X27.5
N490 G40 X-18.4142 Y-.588
N500 G41 G1 X-7.5 Y-172.5
N510 X27.5
N520 G40 X-18.4142 Y-.588
N530 G41 G1 X-7.5 Y-187.5
N540 X27.5
N550 G40 X-18.4142 Y-.588
N560 G41 G1 X-7.5 Y-202.5
N570 X27.5
N580 G40 X-18.4142 Y-.588
N590 M50
N600 M30
%

Similar Threads: