Mits 90SZ servo alarms

[MoraTradgnist]

Hi,

I have a Mitsubishi 90SZ that will not start after moving it to my new shop. The machine started just perfectly before moving it, now I get servo alarm 017 OR 033.
The feeling is that it has something to do with input power. Backup battery is bad so I have to reload software if it's been without power for more than 1 day or so.
I get no alarms on the servo amps while loading the software but when I power it up to load the language disk, the alarms will show.

I have 200V between the phases at the machine but 0V between phase and ground, is this really normal? Since we have 400V here in Sweden there is a transformer before the machine.

Sorry for poor english but I hope you understand!

/R

Similar Threads:

• Fanuc Servo Alarms 401, 414, 424
• Newbie- fanuc servo alarms
• Problem- Fanuc 401 & 414 Servo Alarms
• LNC 8 servo and LDU alarms
• servo alarm 51(current command exceeding) on mits m50l

[MoraTradgnist]

Nevermind, It's running now! I just left it connected to power for a few days and now it starts just fine. Bad battery I guess.