I am having a problem with my Thermal Dynamics auto-cut 100 plasma cutter during the initial spark igniton. I get a spark, but do not get igniton. I have changed the consumables out many times, so I am confident this is not the issue. The problem also seems to be more prevalent with carbon steel than stainless. Any thoughts would be greatly appreciated.
This may be a silly question but have you checked the workclamp connections? Do you clamp to the workpiece itself or just the table? Is your shop air nice and dry?
Our machine is a C&G systems aviator XLT plasma table with a Thermal Dynamics AUTO CUT 100 plasma system. I am concerned that moisture could be in the air line from the shop compressor. Right now we have a Norgren regulator with filter, what else do you reccomend to further reduce the air moisture.
hi steve! can your cutmaster 151 cut at 2mm in height of the piece to be cut? i have this machine but manual system and at 1mm is cutting intermittently
do you know how to solve it? or what i'm doin wrong? the work cable is added from a clean area of the workpiece!
thanks steve.
carlos.
hi steve! can your cutmaster 151 cut at 2mm in height of the piece to be cut? i have this machine but manual system and at 1mm is cutting intermittently
do you know how to solve it? or what i'm doin wrong? the work cable is added from a clean area of the workpiece!
thanks steve.
carlos.
hello i am mitra singh from guyana i have a cutmaster 151 1 of the diodes (D5)on the board is burnt out could anyone please tell me the number for the diodes thank you
Reply with Quote
pilot arc ignition problem
