| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-31-2010, 08:43 AM
| |||
| |||
I am confused regarding the set resistor for the G540 drive and information I read here about resistors for all three motors. Do I need a resistor for each motor or only the one the Gecko manual shows installed on the drive? Thanks, Pat  |
|
#2
01-31-2010, 10:00 AM
| |||
| |||
| One per motor.
__________________ Anyone who says "It only goes together one way" has no imagination. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Can anyone change my SMD resistors? | ger21 | General Electronics Discussion | 19 | 10-27-2009 01:20 AM |
| Help with resistors en capasitors | DimiOrla | Stepper Motors and Drives | 8 | 04-13-2007 10:19 AM |
| Sensing Resistors vs Current limiting Resistors | whitney | Hobbycnc (Products) | 3 | 11-05-2006 11:29 PM |
| braking resistors. | najnielkp | Servo Drives | 2 | 07-07-2006 11:03 AM |
| Resistors!! How hot? | southernexplore | General Electronics Discussion | 4 | 11-19-2005 09:32 AM |
| | |
Linear Mode
