| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-16-2003, 01:40 PM
| |||
| |||
Hi; After trying out my latest CNC project, I noticed the steppers chatter at low speeds particularly when ramping up or ramping down. The steppers run very smooth at higher speeds. I know there is a trim ajustment on the Gecko 201 driver boards. Does this adjustment address the chatter?? If so, how do I adjust, trial and error?? Also, is it possible to change from full step to half or quater steps? How does one do that? Thanks Jim  |
|
#2
06-16-2003, 02:02 PM
| ||||
| ||||
| The lower the steps the smother they will run, I believe. I always ran mine in the mirco step, the steppers with not get as much top speed as a half step, but they cut much better.
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attaching a Stepper | andy_ck87028 | DIY-CNC Router Table Machines | 4 | 12-24-2004 11:09 AM |
| Not good for a stepper motor? | FLUTE HEAD | Stepper Motors and Drives | 4 | 12-01-2004 11:31 PM |
| Stepper Resolution | Max | DIY-CNC Router Table Machines | 5 | 09-05-2004 03:06 AM |
| Fun with floppy stepper and driver | Konstantin | General Electronics Discussion | 5 | 03-08-2004 01:18 AM |
| disassembly of stepper motors | dhprc2 | General Electronics Discussion | 8 | 06-25-2003 07:09 PM |
| | |
Linear Mode
