| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-14-2005, 05:33 PM
| |||
| |||
I just fried a new gecko and can figure out why? I have a 2.1 amp motor bipoler and I didn't miswire or short any wires I am using 53vdc and a 16k ohm resistor (should of been 18k ohms but thought this would be even safer. Want could of caused this? Went up in flames. Don C.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driving a 4 pole ac servo with a 6 pole drive | TommyB | Servo Motors and Drives | 4 | 04-28-2005 01:17 PM |
| Using a large drive on small motor? | murphy625 | General Electronics Discussion | 0 | 03-11-2005 04:23 PM |
| Help! ...no drive movement | CRFultz | General Electronics Discussion | 4 | 01-21-2005 07:30 PM |
| Good DC motor and drive | JRoque | General Electronics Discussion | 11 | 01-02-2005 09:38 PM |
| Fried drive | Don C | Gecko Drives | 3 | 06-14-2004 10:57 AM |
| | |
fried drive 
Linear Mode
