| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-11-2003, 11:52 PM
| |||
| |||
Hi, Just a little show and tell. I'm almost ready to make chips and discovered I need a different printer cable. Need pins at both ends. The steppers lock when powered up so that is a good sign. No smoke either. I'm using the Axxus control board and three Gecko boards to drive 550 oz/in steppers. Probably make chips tomorrow night. I built this with knowledge obtained right here. Thanks for all the pointers. A Servo project will be next. Jim    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gecko vs Rutex | samualt | Gecko Drives | 20 | 10-21-2004 02:48 AM |
| CNC Operator Panel Design | Al_The_Man | DIY-CNC Router Table Machines | 17 | 09-13-2004 01:03 PM |
| Servos or Steppers..... and other gecko related questions | UKRobotics | Gecko Drives | 11 | 04-19-2004 03:14 PM |
| To Gecko, or not to Gecko...that is the question! | samualt | Gecko Drives | 11 | 09-22-2003 09:42 PM |
| | |
Linear Mode
