Need Help! DB9 Connection - CNCzone.com-The Largest Machinist Community on the net!

denz · #1 09-11-2009, 05:29 AM

Some where on CNC zone i saw a post with a link for Db9 connectors with a sort of pcb board and screw connectors. If any body can point me in the right direction it would be most appreciated.

Cheers

tumutbound · #2 09-11-2009, 08:14 AM

Are these or these what you're looking for?

Check out these too.

denz · #3 09-12-2009, 05:49 AM

Thanks Geoff its the "or these" i was after, bit pricey though.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
cnc connection	nona	Excitech routers	2	08-28-2009 12:54 PM
Need Help!- TRA 30A Connection	stevenchan	Mazak, Mitsubishi, Mazatrol	3	07-18-2009 03:41 PM
Problem- DNC connection	allenkimber	Computers and Networking	5	08-04-2008 12:58 AM
What is NC NO connection?	mealman	General Electronics Discussion	4	10-15-2007 05:59 AM
Connection	bbrreid	Mazak, Mitsubishi, Mazatrol	5	07-15-2007 03:13 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)