G540 Wiring

[clamps]

I currently have :
* G540
* KL-600-48 48V/12.5A
* (3) KL23H286-20-8B (info sheet : http://www.kelinginc.net/KL23H286-20-08B.pdf)

Do I want to wire these steppers in Bipolar Parallel?

If so, what should be the impedance for the current set resistors on the G540? 2.8k ohm?

Thanks
-clamps

[jalessi]

Do I want to wire these steppers in Bipolar Parallel?

Yes.

If so, what should be the resistance for the current set resistors on the G540? 2.8k ohm?

Yes.

[clamps]

Originally Posted by jalessi Do I want to wire these steppers in Bipolar Parallel? Yes. If so, what should be the resistance for the current set resistors on the G540? 2.8k ohm? Yes.

Thanks for the reply.

To wire the motors Bipolar Parallel is this the correct wiring scheme? :

Pin 6 => grn/wht + blk/wht
Pin 7 => grn + blk
Pin 8 => blu/wht + red/wht
Pin 9 => blu + red

Thanks again for the help.

[jalessi]

To wire the motors Bipolar Parallel is this the correct wiring scheme?

Pin 6 => grn/wht + blk/wht
Pin 7 => grn + blk
Pin 8 => blu/wht + red/wht
Pin 9 => blu + red

Yes you are 100% correct, no need to worry,

Jeff...