The Great List of Gecko/PS/Stepper Motor combo's...

[nate]

I think it would be very helpful to myself and the Gecko using community as a whole to have users of Gecko drivers post in this thread their specs. I envision a kind of master refrence list with each person posting the following info in the following format-

Z AXIS SETUP-
1. Gecko Model.
2. Current set resistor.
3. P.S. name and specs.
4. Motor type and specs.
5. Motor wiring used.
6. reduction? and if yes, the type (gear/belt/rack etc) and Ratio.
7. motion control software and applicable settings.
8. Machine use?
9. User/ Builders notes...
10. Is machine currently in use, or still in the design/build/retrofit stage?

A master list like this would be most useful for people to check their settings against, and use during the design/retrofit of a machine, and the selection of needed parts.

I will start the list.

Z AXIS SETUP-
1. G203V
2. 180K.
3. Keling 70V 10A.
4. Pac/Sci Model K31SSFS-LEK-SS-02. 35V 5.5A.
5. Bipolar Series.
6. Yes, belt, 1.8:1
7. Mach 3.
8. Lathe/ Mill.
9. Scratch built machine.
10. Machine is still in the design/build stage.