| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gecko Drives Discuss all Gecko drives here and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-08-2009, 07:13 PM
| |||
| |||
Will the servo drivers shut down if they go to far in error or just time out? I am trying to set up a new complete 3 axis controller for a second gantry router. My first cnc router uses different drivers and shuts down all three driver boards if one faults and i must reset all three before I am up and running again. Thanks Tommy  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Differences between G320 and G340? | phantomcow2 | Gecko Drives | 5 | 09-02-2006 06:29 PM |
| | |
Linear Mode
